Furnace Repair Services in Skippack Township, PA
- Locally Owned & Operated
- Trust & Transparency
- Long-Term Relationships
Nearly every heating system in Skippack Township needs electricity to run, including the ones burning oil or propane. The burner, the blower, the controls, and the safeties all depend on power, so when a winter storm takes down a line out here, the heat goes with it regardless of how full the tank is.
Davis Modern Heating & Cooling repairs heating equipment throughout the township, from Skippack Village out toward the Perkiomen and Evansburg. We have been family owned since 1850, we service every brand, and we work across natural gas, propane, heating oil, and electric.
Our Services
- Boiler Installation & Replacement
- Boiler Maintenance
- Boiler Repair
- Furnace Installation & Replacement
- Furnace Maintenance
- Furnace Repair
- Geothermal Heat Pump Installation & Repair
- Heat Pump Installation & Replacement
- Heat Pump Maintenance
- Heat Pump Repair
- Oil Furnace Repair & Maintenance
- Convert From Oil Heat
- Radiant Floor Heating Installation & Repair
- Tankless Water Heater Installation & Repair
- Water Heater Repair
- Water Heater Replacement & Installation
Contact Us
- This site is protected by reCAPTCHA
Signs Something Is Wrong With Your Heat
Once the power is back, these are the signs your system did not come through it cleanly.
- Furnace not restarting
- Control board unresponsive
- Thermostat blank or resetting
- Burner locking out immediately
- Blower running continuously
- Breaker tripping at startup
- Burning smell after restart
- Error code displayed
- Heat weaker than before
- Any alarm sounding
Repeated resetting after an outage tends to make a damaged control worse rather than better.
No Power Means No Heat
Rural distribution lines run long distances through wooded country, so momentary interruptions and full outages are simply part of winter here. Each one is a stress event for the equipment connected to it, and control boards, transformers, and low voltage fuses are the components that absorb it. A furnace that worked yesterday and will not start today often has an electrical cause rather than a mechanical one.
Restarts are their own risk. When power returns, everything in a house attempts to come back at once, and the surge that follows is harder on electronics than the outage itself was. Furnaces frequently fail on the return rather than on the loss.
Then there is what happens while the power is out. A house without heat in January loses temperature quickly, and out here where plumbing often runs through unheated crawl spaces and older farmhouse walls, an extended outage becomes a frozen pipe problem. Knowing how long a house can hold is worth more than most people think.
Heating Repair When the Power Comes Back
After an outage we check the electrical side first, including incoming power, transformers, low voltage fuses, control boards, and thermostat operation, before moving to burner and blower diagnostics. That order saves time, because the fault is usually electrical.
Our regular work covers furnaces, boilers, oil furnaces, heat pumps, thermostats, ductwork, and ventilation on every brand and fuel. Ignition and flame sensing, fuel pressure, safety controls, venting, temperature rise, and heat exchanger inspection are part of every heating call regardless of what brought us out.
Where a control or a system cannot be safely restored, we say so and explain the options across all fuel types. We can also talk through surge protection at the equipment, which is a modest addition on properties where flickers are routine.
Skippack Village After the Lights Came Back
Ellen called from near Skippack Village the day after an ice storm knocked out power across the area. The lights had come back that morning, the furnace had not.
Our technician found a blown low voltage fuse and a control board that had taken damage during the restart, along with a thermostat that had lost its configuration. We replaced the fuse and the board, reconfigured the thermostat, checked the burner and heat exchanger, and confirmed the furnace ran through several complete cycles.
The house was warming within the hour. We also went over surge protection at the equipment, since that stretch of the township sees this pattern most winters and the same failure tends to repeat.
Where We Stand in Skippack Township
Here is what comes with our name on the invoice.
- Family owned since 1850
- Outage and surge related repairs
- Farmhouse and new build experience
- 24/7 on-call technicians
- Licensed in Pennsylvania
- All brands and fuels serviced
- Electrical and combustion diagnostics
- Straight answers every visit
Our on-call service runs around the clock, which matters most in the hours after a storm when half the township is calling about the same thing.
Frequently Asked Questions
Why did my furnace stop working after a power outage?
Control boards, transformers, and low voltage fuses commonly take damage during an outage or the restart that follows. It is usually an electrical repair rather than a mechanical one.
Does my oil or propane furnace still need electricity?
Yes. The burner, blower, and controls all require power, so a system with a full tank will not run during an outage.
Is emergency heating service available?
Yes. We have technicians on call 24 hours a day, seven days a week, including after storms.
Should I keep resetting a furnace that will not start?
No. Repeated resets can worsen damage to a control board or flood a combustion chamber. One or two attempts is enough before calling.
Is surge protection at the equipment worth it?
On properties where flickers and outages are routine, it can protect control boards and other electronics for a modest cost.